Moving dual axle trialers with ease

[AllyFishing]

I just watched the video again. Yep, the video shows the attachment block on top of the 2 wheel skate but the pics and documentation that comes with it shows it underneath between the wheels. I put it on top.

[Chisco]

Thank you sir....I'm going to order one. Just hope no one steals it at the ramp.

[xb03fs]

So I was thinking what would be bad ass for tight garages could be to make a platform with linear bearings. Back the trailer onto the plate then slide towards the wall.

If I get a deep enough garage it will be made. Ideally I would want to keep the overall height 2" or less for the platform.

[AllyFishing]

Thank you sir....I'm going to order one. Just hope no one steals it at the ramp.

That's why I used a bolt and nylock nut instead of the pin and clip. Of course, someone with the right tools in their vehicle can have it off in a heartbeat at least they will have to get their tools out and take a chance of not getting caught.