Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Mar 2014
    Location
    Palatka FL
    Posts
    87

    Help with pp bracket spacer for bobs jackplate

    '01 gambler
    225 efi

    just bought a 8' blade and I'm getting ready to mount it. I have a 6" bobs hydraulic so I had to buy the spacer to fit into the recessed area of the jackplate. The directions are horrible. There are eight 1/2" holes in the spacer (4top and 4 bottom) how many holes am I suppose to do? Directions for the bracket show one bolt on the top and one on the bottom but then says spacer does not come with hardware. can I drill out just one hole for top and one for bottom?

  2. BBC SPONSOR
    Join Date
    Jun 2004
    Location
    South Florida
    Posts
    6,066
    #2
    The hardware comes with the Power Pole adapter plate. Not the spacer.

    1 bolt in top, 1 bolt in bottom

  3. Member
    Join Date
    Mar 2014
    Location
    Palatka FL
    Posts
    87
    #3
    Ok thanks! Is the spacer suppose to fit perfectly in the recessed part of the jackplate? It doesn't seem to fit down flush in there. The spacers angle is a little off

  4. Member
    Join Date
    Mar 2014
    Location
    Palatka FL
    Posts
    87
    #4
    The spacer is just barely bigger than the recessed area