Thread: SHO trim

Results 1 to 8 of 8
  1. 04-15-2017, 03:22 PM #1
    Machine Concepts
    Machine Concepts is offline
    Member
    Join Date
    May 2014
    Location
    Mt. Washington,Ky.
    Posts
    2,178

    Question SHO trim

    Any of you guys had trouble with trim bleeding off during a run? 250 SHO. Cylinder seals are not leaking that I can tell. I have not checked if reservoir is low yet.
    Reply With Quote Reply With Quote
  2. printman71
    printman71 is offline
    Member
    Join Date
    Aug 2016
    Location
    Varnell, GA
    Posts
    7,466
    #2 04-15-2017, 05:52 PM
    I am on my second 250 SHO with no issues as you note to report.
    Reply With Quote Reply With Quote
  3. Rich Z
    Rich Z is offline
    Banned
    Join Date
    Jun 2004
    Location
    Apex, NC
    Posts
    4,828
    #3 04-17-2017, 06:12 AM
    Ensure the manual by-pass valve is tight.
    Reply With Quote Reply With Quote
  4. poorboy2
    poorboy2 is offline
    Member
    Join Date
    Mar 2012
    Location
    Dentsville,MD
    Posts
    91
    #4 04-17-2017, 06:45 AM
    second on the manual by pass valve. my dads was doing the same and then we tightened the screw and that fixed it
    Reply With Quote Reply With Quote
  5. Skeeter9948
    Skeeter9948 is offline
    Member
    Join Date
    Mar 2014
    Location
    Edwardsville, Kansas
    Posts
    130
    #5 04-17-2017, 10:47 AM
    When you tighten that manual by-pass valve be sure you don't go hammer on it.....just get it good and snug.
    Reply With Quote Reply With Quote
  6. Machine Concepts
    Machine Concepts is offline
    Member
    Join Date
    May 2014
    Location
    Mt. Washington,Ky.
    Posts
    2,178
    #6 04-17-2017, 12:41 PM
    Thanks so much guys!! I'll give it a look
    Reply With Quote Reply With Quote
  7. Machine Concepts
    Machine Concepts is offline
    Member
    Join Date
    May 2014
    Location
    Mt. Washington,Ky.
    Posts
    2,178
    #7 04-17-2017, 04:49 PM
    Gentlemen that was it! It turned about a quarter turn. Thanks again!! Rich Z send me a bill. Lol
    Reply With Quote Reply With Quote
  8. Skeeter9948
    Skeeter9948 is offline
    Member
    Join Date
    Mar 2014
    Location
    Edwardsville, Kansas
    Posts
    130
    #8 04-18-2017, 08:02 AM
    Good to hear!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »