2014 250 Pro XS
2B021192
this is on starboard side top of engine was this cut out if so why?
where does this wire go looks out of place
2014 250 Pro XS
2B021192
this is on starboard side top of engine was this cut out if so why?
where does this wire go looks out of place
Rick Someillan
Lacoochee, Florida
2016 21 TRX
250 Pro XS
They cut it to allow air to the motor.
Rick Someillan
Lacoochee, Florida
2016 21 TRX
250 Pro XS
That's a Factory modification.
That is not the quality that I would expect from Mercury. All those small pieces of plastic are going right down in your motor
Won't hurt anything....no big deal.
The cover is cut out before it is installed on the engine on the assembly line , non plastic shaving get in the engine just the floor at the factory. and that is the port side of the engine
The hole is normal, the wireloom going in through the lower cowl is not normal. It looks like the trim motor might have been replaced and the tech couldn't get the wires back through the rubber grommet in the lower cowl? It should go through the same hole as the wire pictured to the right.
Fastbass Marine LLC
We specialize in NEW and USED ALLISON BOATS, Blazer Boats, Platinum Mercury Marine Repower Center, AquaTraction Flooring, and custom marine electronic installations on beautiful Kentucky and Barkley Lakes.
2022 Allison XB-21 BasSport Pro Elite
2022 Mercury 450R
2012 Bullet 21ss
2005 Mercury 300X
https://youtu.be/FOnAGNWOgZ0
Holy cow who the "F" would run that harness through the lower cowling like that......What a hack job!
Wow!
That wire job is a real beaut
Ryan Bauman 2022 Ranger 520R 250 Mercury ProXS Fourstroke
WOW.
Send that one back to "screwdriver 101".
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor