Has anyone put HDS9's on their tracker? I'd like to see how you mounted them on the helm and bow.
Thanks in advance!!!
Has anyone put HDS9's on their tracker? I'd like to see how you mounted them on the helm and bow.
Thanks in advance!!!
I can take some pictures tonight. I have them at the helm and bow on ram mounts.
I'd would really appreciate it. I have them on order now, just trying to prep for the mounting location etc.
Thanks Jeff, I planned on doing that anyway since my boat doesn't have a bow unit or the wiring.
What year is your 175? I haven't seen or heard of one yet that isn't prewired for the graph at the front.
My neighbor has 2 on his tracker, 1 on a ram mount and the other on a dek it mount!
I had to work late today. I will snap some photos tomorrow.
I have the same ram mount and cable organizer on the console on my pt175 and humminbird 898. Its very solid and i like it. As far as the wiring i have 3 graphs wired to the factory fuse box one at the bow with the factory rigged harness and have zero issues with interference anything. Been that way for almost 3 years now.
Roy
2020 Triton 18 Trx
Mercury 200 Pro XS V8
Bravo FS 24P Prop
Atlas 6” jp
Dual Humminbird Helix 10 MEGA SI
Minnkota Ultrex.
Transom that Ram mount looks familiar.
Roy
2020 Triton 18 Trx
Mercury 200 Pro XS V8
Bravo FS 24P Prop
Atlas 6” jp
Dual Humminbird Helix 10 MEGA SI
Minnkota Ultrex.
Thanks guys. I have a 2016 175TXW and I don't see any wiring at the bow for a finder. I did add the 80lb Ulterra this weekend, it's awesome.
There should be wiring there. My parents have a 2016 PT175 TXW and it was there. My 2013 had it, too.
I don't always tell people where I fish, but when I do, it's a lie.
Basskisser is it in the trolling motor/motor switch harness?
I did not look for wiring for mine. I ran a 10 gauge duplex cable from the console fuse panel and installed a small 4 circuit fuse panel and ground bus bar under the bow panel.
I haven't had any issues running my Helix 10 off of the factory 18g wire. I did run separate 14g for the 360 tho.
2020 Ranger RT188P
Mercury 115 ProXS CT/23P Tempest/Atlas Hydraulic 6”/Sportsman 2 Powerpoles/Ultrex 80
Humminbird Helix 9 MSI/Humminbird Helix 9 MDI+/Humminbird Mega 360
I don it think a new circuit is needed for a single finder. However I was going to run two and having the power up there for additional circuits in the future is worth the small cost IMO as you are running cables between the console and bow anyways.
It was under the front panel where the plug for the trolling motor is. The wires were just sitting there and it was obvious they were for a 12v accessory. They're hot. Yours might be hidden or didn't quite make it as far as ours. Try reaching through that small hole and see if you can find them. It'll save you some time and work if you can.
Sorry it took so long to answer, I'm traveling and this was my first chance to reply.
Thanks guys, I'll have to check again when the graphs come in.
Do you guys have any suggestions on mounts? I've heard bad things about RAM mounts, no offense to anyone, just want to know your opinions.
I've also been looking at http://www.balzoutllc.com/, any thoughts?
Last edited by ttourikis; 04-03-2017 at 08:00 AM.