-
Prop torque question
Guys. I have a VMAX HPDI 175 with a 25M prop. prop is currently getting worked on and i can't find what to set the torque to when i get it back and put it back on. Any suggestions?
-
Use the owners manual. Available to you at www.yamahaoutboards.com
Also, retorque the nut after the first hours use. Not specified in the OM but good practice. Inspect the propeller from time to time during use. Catch a loose prop nut early and no harm no foul. Catch it too late and you may be buying a new propeller and gear case.
-
Don't you just torque it to the point where you can get the cotter pin hole lined up?
-
It is normally torqued to the value specified in the owner's manual/service manual. Then tightened further as needed to get a cotter pin hole lined up.
-
Torquing the nut further to get a cotter pin to line up is the normal procedure. Never loosen it to get the pin lined up.....learned that the hard way haha.