Page 1 of 2 12 LastLast
Results 1 to 20 of 21
  1. #1
    Member
    Join Date
    Dec 2013
    Location
    Berlin Center Ohio
    Posts
    507

    Update for Helix G2 Mega units now Available

    Just downloaded but haven't installed yet. Checked my Humminbird info page on my account and download was posted.
    Helix Mega 10 SI G2N , ILink
    Garmin 1040 XS / Garmin 1242 xsv with Panoptix Down VU PS 30 W/ GCV 10 networked with PS 31. Boat Rig

    Echomap Ultra 106 SV with Livescope 12 . Ice Rig

  2. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,445
    #2
    The Helix 12 CHIRP SI GPS got an update also 1.400. So far it is a dud.
    First two times I inserted the memory card, the unit shut down when using Simulator trying both card readers.
    I copied the file to another memory card and it did the same.
    Next few times in Normal with a transducer connected, it just ignored the card.

    Deleted the download, did it again, and the unit still ignores the software in Normal or Simulator.

    I did the Default Setting before attempting the install.

    The 1.400 file size is almost 20,000 less KB than 1.350.
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL

  3. Member
    Join Date
    Jan 2012
    Location
    Barbourville ky
    Posts
    48
    #3
    I have 2 gn2 12 would wait before installing the new software.

  4. Member
    Join Date
    Feb 2015
    Location
    southside tn
    Posts
    948
    #4
    i down loaded helix mega helix 10 g1 helix 5g2 and helix 7g2 i am going to wait before installing any of them wayne keep me posted what is going on with yours. called humminbird they said even though the down loads all were 1.40 still had to have separate down load for each unit, so i am holding on all four until i here they are working.
    Last edited by BBW; 03-23-2017 at 11:54 AM.

  5. Member
    Join Date
    Jun 2013
    Location
    Hemet, CA
    Posts
    4,659
    #5
    When I checked for the Helix 10 SI/GPS (G1), it shows 63.8MB on the update. I think I'll wait before doing an update on the HELIX12 CHIRP model for now. And yet again I received no update notice from Humminbird. Thanks to this forum for the heads-up notices.
    Wes
    Helix 10 MSI+,MDI+,Ultrex IPilot
    2023 Phoenix 818
    Never assume there's a tomorrow

  6. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,445
    #6
    Quote Originally Posted by BBW View Post
    i down loaded helix mega helix 10 g1 helix 5g2 and helix 7g2 i am going to wait before installing any of them wayne keep me posted what is going on with yours. called humminbird they said even though the down loads all were 1.40 still had to have separate down load for each unit, so i am holding on all four until i here they are working.
    You won't have the same software I do. Yours may be OK.
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL

  7. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,445
    #7
    Update, I got another version that is 65,645 KB and looks very good so far. Installed with no issues.

    I checked a few things that were "glitchy" with 1.350 and they are OK. I'll test on the water tomorrow.

    Helix 12 CHIRP SI GPS
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL

  8. Member
    Join Date
    Jan 2017
    Location
    Texas
    Posts
    88
    #8
    Do you know if they fixed the issue where the right side of the si view on a combo view screen is overtaken by the down imagining with the sharpness turned on low med or high? Called humminbird an hour ago and she was not sure and was going to test that on one of their units. Will report back when I hear if no one chimes in.....

  9. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,445
    #9
    Quote Originally Posted by Coachzee20 View Post
    Do you know if they fixed the issue where the right side of the si view on a combo view screen is overtaken by the down imagining with the sharpness turned on low med or high? Called humminbird an hour ago and she was not sure and was going to test that on one of their units. Will report back when I hear if no one chimes in.....

    Does not do it in Simulator, will check on the water tomorrow.
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL

  10. Member
    Join Date
    Jan 2017
    Location
    Texas
    Posts
    88
    #10
    Thanks Wayne, when updating my helix 9 mega g2n si gps, can I do it in simulator mode? Should I do it in normal mode and turn off the sonar so it's not pinging in the garage or start up in normal mode and just disconnect the transducer connection from the head unit?

  11. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,445
    #11
    Quote Originally Posted by Coachzee20 View Post
    Thanks Wayne, when updating my helix 9 mega g2n si gps, can I do it in simulator mode? Should I do it in normal mode and turn off the sonar so it's not pinging in the garage or start up in normal mode and just disconnect the transducer connection from the head unit?
    Simulator is fine. IF you must do it in Normal, the instructions would state that.

    Some ONIX software versions were like that.
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL

  12. Bringer Of The 'Bird sfw1960's Avatar
    Join Date
    Mar 2010
    Location
    White Cloud, MI
    Posts
    3,881
    #12
    I updated my (gen1) H12SI using the Simulator today, and found the radar view won't stay hidden (still)..

    The noise filter menu has been restored - a bunch of fixes listed ~ so some time on the water will tell.
    Robert
    Newaygo CTY, MI
    Helix12MSI G2N v1.84/Helix10MSI G2N v1.84/Helix10MDI G2N v1.84/ASGPSHSx2/iPilotLinkv2.15/2.04RC-1+2/


  13. Banned
    Join Date
    Mar 2011
    Location
    Clarks Hill Lake
    Posts
    20,875
    #13
    why do you guys update in simulator?

  14. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,445
    #14
    Quote Originally Posted by TroyBoy30 View Post
    why do you guys update in simulator?

    I do mine on my desk.
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL

  15. Bringer Of The 'Bird sfw1960's Avatar
    Join Date
    Mar 2010
    Location
    White Cloud, MI
    Posts
    3,881
    #15
    Quote Originally Posted by Wayne P. View Post
    I do mine on my desk.
    Me too.

    I will probably do the H12DI unit in the garage, as I have the boat shredded ATM....
    Robert
    Newaygo CTY, MI
    Helix12MSI G2N v1.84/Helix10MSI G2N v1.84/Helix10MDI G2N v1.84/ASGPSHSx2/iPilotLinkv2.15/2.04RC-1+2/


  16. Member
    Join Date
    Jul 2012
    Location
    Cohutta Georgia
    Posts
    907
    #16
    I picked up a 10 Mega yesterday... should I download the update or wait?

    Greg

  17. Banned
    Join Date
    Mar 2011
    Location
    Clarks Hill Lake
    Posts
    20,875
    #17
    Quote Originally Posted by Wayne P. View Post
    I do mine on my desk.

  18. Bringer Of The 'Bird sfw1960's Avatar
    Join Date
    Mar 2010
    Location
    White Cloud, MI
    Posts
    3,881
    #18
    Quote Originally Posted by Blue76 View Post
    I picked up a 10 Mega yesterday... should I download the update or wait?

    Greg
    I flashed my 12SI machine Y/D and it fixed quite a few things, Wayne is OTW testing right now I think.

    Nice that you found one!

    Where did you get yours Greg?? (PM if you want)


    RAS
    Robert
    Newaygo CTY, MI
    Helix12MSI G2N v1.84/Helix10MSI G2N v1.84/Helix10MDI G2N v1.84/ASGPSHSx2/iPilotLinkv2.15/2.04RC-1+2/


  19. Member
    Join Date
    Jan 2017
    Location
    Texas
    Posts
    88
    #19
    How did the otw test go Wayne, be curious to know before I update my mega 9 this weekend.....

  20. Banned
    Join Date
    Mar 2011
    Location
    Clarks Hill Lake
    Posts
    20,875
    #20
    ------
    Attached Images Attached Images

Page 1 of 2 12 LastLast