Wiring a PS 30 and PS 31

[dakota floyd]

I am wiring a PS 30 and PS 31. I have a transducer stick from fishing specialties which has a hollow center and I was going to run both the power wire and transducer from the PS 30 wire up the center of the shaft. Is this going to cause interference? The only other option is to run the power on the outside of the stick on one side since the wiring from the PS 31 will also be on the outside. I would have to try and run both power wires on one side of the stick and the transducer on the other. Thanks for the help

[Treeguyus]

It could but you won't know until you try it. Honestly my cords run together and experience no issues.

Would be best to run down the center though.

[DonnieG]

I had the same transducer stick with the transducer & power wires from the PS-30 running inside the tube.

No interference on the PS-30..

[Larry3215]

You wont have a problem. They come bonded together from the factory. You cant get them any closer than that.

[DonnieG]

PS-30 cables are not bonded. PS-31 is probably the same..

[Larry3215]

Oops. Thats what I get for ass-uming.... :)

I still doubt there would be any issue. These are not like trolling motors and dont generate that same kind of noise/interference.

[dakota floyd]

thanks for the help