Hey all,
Recently I have noticed when I drop my Power-Pole down by double tapping the switch, sometimes when it makes bottom contact it continues to run and go further into the bottom. It will also do the same when I bring it up and I have to hit the switch again to stop it. Is this a motor problem or a switch problem?
Thanks
Did you recently tighten any hardware on the pole? It can cause this to happen.
if not then you need to adjust your sensitivity. you can do this thru the App.. You can adjust both the up and the down sensitivity.
Not a motor or switch problem no...
Yep, adjust the sensitivity up. One of my 2 blades that I installed yesterday will continue to run even though it's retracted fully. Today I'm going to tweak all the settings through the app.
Is this C Monster App?
YepOriginally Posted by redfish2726
Yes
OK, relative question here, when I go to the app and try to change the setting via the slide indicator, it always returns to 5(default setting) what am I doing wrong?????
Disregard, I had app set to return to default when app started, duh......By the time I figure out how to run these and an ultrex Ill be too old to use em.......
boats will soon come with manual Holders...
Get the app for your smart phone, it works great
Power Pole Staff
Seaguar VIP
Team Ardent Pro Staff
WOO Tungsten
Amphibia Pro Staff
Hayabusa Fishing Hooks
Keitech VIP
Revital Outdoors Pro Staff
Titan Lures
Amsoil
Lowrance State Team
JB's Fish Sauce
Str8 Up Mounts Pro Staff
Read above ..he already does what he was talking about using to adjust his sensativity
If one pump runs a little longer than the other and u useing the app say the one shutting off and other runs a little longer which way you go. Say up is on 5. Slide it to 7 or to 3
I'm having the same problem and the app sensitivity level up or down dont change a thing. Did you figure out ur problem?
If the unit continues to run once retracted,increase the sensitivity. If the unit stops running prematurely,decrease the sensitivity. If the unit turns off prematurely during deployment, decrease the sensitivity.
If the unit continuous to run once anchored, increase the sensitivity. Please make sure you have the latest firmware installed as well.
Firmware is updated and the sensitivity dont help. If I hold the down button to lower poles then double tap to raise them everything is fine the pumps shut off once poles are up. But if I double tap down then double tap to bring the poles up the pumps continue to run for10 sec.
Update if the speed of power poles stay under 60% everything works perfect.
Call Power Pole and they will run a diagnostics thru your app.
Just did yesterday they r sending new pumps. Great customer service!
Does temperature make a difference? Mine does that on cool mornings I have noticed. I thought is has to do with the viscosity of the oil at cooler temps. After a couple times up and down the oil warms up or the lines get full enough to make quicker responses. Just a thought. Mine seems to work it’s way through the problem. Never does it in the summertime.
During cool weather, the pumps will automatically slow down their speed. The reason for this is cold hydraulic fluid does not move through the pump as efficiently as it would in warmer temps so they slow them down slightly to improve the bottom sensing and anchor stowed shut off. This speed will increase as the ambient temperature rises or continued operation "warms" the unit up.
Reply With Quote