-
2016 150HP 4 cylinder 4 stroke tilt limit adjustment
Hi all, my first post and looking for some advice.
Briefly: New install - set up the trim/tilt limits via the Smartcraft SC1000 tacho gauge but the tilt up range is still too much - cowling just contacts vessel at full tilt travel.
There are no orange wires to manually setup and the 'tilt limit' in the diag software is greyed out. Is the tilt module an optional extra even on the 150/175 models as well as the 115 or is there something I'm missing.
Thanks for your help in advance.
-
From what I understand trim limits are set in the programming of the motor and has to be done with computer at dealer.
-
Mercury 3L/4 Stroke/Verado Moderator
Please see the Forum Announcements, and be sure to provide the REQUIRED info when posting. Thanks!
Part# 8M0072610 is required to achieve Tilt Limit functionality.
-
Ah, was under the impression it was standard on 150/175's
Thanks
-
Where would this unit be mounted if it was fitted, on the lower port side of the powerhead?
-
Post your serial number for better info..
-
It's 2B4... 150F...
Thanks
Last edited by Boater_buoy; 03-22-2017 at 03:08 AM.
Reason: confidential
-
Mercury 3L/4 Stroke/Verado Moderator
Port-Front corner, usually.
-
Thanks, it's not fitted. Cheers for all the assistance.