Hi Guys,
I was playing around with my boat last night and noticed that one power pole was not working (which I later found out was due to being out of fluid). During my problem solving, I removed the caps to the fuse holders and noticed both fuses were bubbled up and looked melted. When I pulled the first fuse, one of the male ends stayed in the fuse holder. when I pulled the other one it came out with no problems. One of the fuse holders is in good shape and the other looks melted. I then started to look at the wiring (which I did not install), and noticed the factory connectors were removed and replaced with male and female connectors. below is a picture of the wiring. The problem I noticed, if I put a fuse in one of the relays, both motors still operated and ended up blowing the fuse. But if I put a fuse in each of them, they operated and did not blow the fuse. Looking at my diagram below, is there anything wrong with the way they are wired?
thanks,
Nick