I got the rapala one pictured above mounted to my drivers console on the side. I built this one for the front trolling motor tray I put in.
I got the rapala one pictured above mounted to my drivers console on the side. I built this one for the front trolling motor tray I put in.
Made a pedal tray cover to hold just a pliers and braid scissors - also manages pedal cables.
1-traycover.jpg
3-traycover.jpg
I bought the Repala tool storage and the double sided tape didn't hold so I bought some silicone adhesive that works great.
I found one on this forum not sure where, but it has 3 suction cups and attaches anywhere on the boat. I ordered it from tacklewarehouse. I works great. I fish Lake Erie and no problem staying in place. For the money about 19.00 and no drilling holes it is the deal. Hope it helps
Last edited by rangerbobber; 04-16-2017 at 01:09 PM.
Last edited by cfm56doc; 04-19-2017 at 02:42 PM.
2013 Z118 w/Merc 150 4S
This is what I use also. https://rogersproductsinc.com/product/handie-hold-it/
Bill
I clamped two cell phone holders on my pedestal. Holds everything from pliers to scent
Here is a picture of it installed on my Ranger Z118. The holder is about 1" too long for my application, but I cut an inch off the right and and it fits perfectly! Love hoe it keeps the TM harness off the bow screen when the TM is deployed.
I did have to move my TM pedal aft a little bit, but nothing rubs at all while using the TM pedal.
2013 Z118 w/Merc 150 4S
I just use aplastic coffee can with a X cut in the bottom and my seat pole stuck thru it. But, then again, I am a cheap bastard !
Matthew 4:19 - "Come, follow Me," Jesus said, "and I will make you fishers of men."
I jut us an empty coffee can with an X cut in the bottom and my seat post stuck thru it. Works for me !
I have an old or should I say new old stock fish formula holder got it from Basscatfrank thanks again, it holds my smelly jelly and real magic or bang whichever I have at the time plus pliers and hook extractor and baits around the side as well and a little cut out on the bottom for other stuff as well I'll try to get a pic of it to post
1990 374V Ranger Still kickin' bass after all these years
IMG_20161207_100928634_crop_590x590.jpg
Like some of the others. Get a plastic cutting board, some cupholders, and spacers. Make it how you want to.
Made a pattern out of cardstock of what I wanted, then traced it onto some 1/8" thick aluminum sheet. Cut it out on, then bent it to the shape I wanted in a vise. I used a rubber grommets in the holes I drilled for the tools, and a short bungee cord to keep tools put when running down the lake or highway. To secure it, I used a piece of threaded rod and a turnbuckle on the bottom to clamp it firmly inside the trolling motor tray.