I did the prop and pad measurement up top and came out with 4.5". Pad was 15.75 and prop shaft was 11.25. I have one more hole on the engine bracket, no jack plate, which would raise engine approximately an inch. Boat usually runs 58 at 5650 rpm wide open with 2 guys with a 25p Renegade 4 blade. Other prop is slower 26p original Raker. Thoughts?
That boat should fly in at around 68mph. Try getting a hold of 24 fury or 25 tempest plus 3 large plugs
You should be able to get another 10 mph out of it with the Tempest+ but you will need a jackplate to do it,6" plate at 2.75 under.
If I put on a jack plate I won't be able to fit the boat in the garage. Do you think raising the engine up to the last hole, approx. an inch, and trying a new prop would get me into the lower 60's?
25 Tempest should be the best all around prop on that hull.
renegade shud run 3.25 below the pad
2020 Ranger Z519 | 2020 Mercury Pro XS 225 4S | Helix 10SI | Helix 10 MDI G3N | Helix 10 MDI G3N | Noco GENIUS 10X4
Fury 3 22P True Pitched | Power Pole Pro 2's | Ghost TM | Mega 360 | MEGA LIVE | Atlas 8in Jack Plate | Trick Step | 3X Amped 80ah Lithiums
You can try raising it but it might not help or run right without a plate and your already slipping too much where it's set now. It would run better with a 24" raker that 25" 4 blade prop is probably too much for the 200 HO
Last edited by mdtritn21; 02-16-2017 at 03:47 PM.
Reply With Quote