I read on here somewhere that one boat owner was questioning whether the Ultrex 45" would still have the same amount of shaft length in the water as a MG 45" given the fact that an Ultrex/Fortrex has a larger/higher mount at the end where the shaft goes thru than a MG of equal length? This is a good observation and got me wondering. My MG Tour lays low and flat on the front as compared to what I see a Ultrex/Fortrex does.
Does this make sense? Has anyone actually measured how much TM shaft is below say the rub rail of each motor if the shaft is all the way down on the mount?