I currently have a 12 gen3 at the console with structure scan and a 9 gen 3 on the bow that has my sonar from my troll motor connected to it. I'm wanting to know if there is a way I can get my structure scan to work on my 9 at the bow?
I currently have a 12 gen3 at the console with structure scan and a 9 gen 3 on the bow that has my sonar from my troll motor connected to it. I'm wanting to know if there is a way I can get my structure scan to work on my 9 at the bow?
2017 Triton TRX Patriot w/250 ProXS Optimax
Connect both locators together via ethernet. Once this is done you can choice the structure page. On the pull down menu at the very bottom should be a source tab. Tap it and choice your HDS12 Gen3 as the source. Assuming the 12 is the only other source you should have only two sources, "this unit, and the 12.
You may have to also activate the structure scan in the settings, advanced, features, structure if the structure page is not present.
good luck.
Thanks I'll try it next time out
Precision Sonar & Outdoors
Home of the Patented Smart Bracket Console Mounting System
website: http://www.precisionsonar.com
email: ryank@precisionsonar.com
phone: 270-703-6133
Just depends on what you want. If you want to see side/down scan from what is under TM then you will need the ss2 transducer or the all scan. If you are ok with seeing what is off back of boat just connect the two via Ethernet like mentioned above.
2004 Triton TR21X * 2021 Mercury 250 4 stroke
Thanks guys. I finally got it figured out.