Ultrex US2 with trolling motor transducer mount

[fishfood]

On a side note, I saw a pic of the bow of a boat (looking at the bow) on here somewhere of what I think was either a Terrova or an Uterra with the US2 on the lower unit and in addition another transducer mounted as well. Where does the ducer wire get routed if the TM shaft goes up and down thru the mount?

Folks have come up with all kinds of ways to mount transducers on those two motors. The Ulterra is tough because there is no way to use the shaft grove but it has been done.

[Buggy Miller]

FYI, I bought a 1.25" collar for my 52" shaft Ultrex and it was too small. A 1.313" (1 5/16") fit perfectly.

[dusty_allen]

FYI, I bought a 1.25" collar for my 52" shaft Ultrex and it was too small. A 1.313" (1 5/16") fit perfectly.

Are these measurements ID or OD? The person before mentioned you need a 1.25" ID.