Getting my 99 201DC ready for next year....
Getting my 99 201DC ready for next year....
What all have you got planned to do on it?
Hey DieselMike, we are doing A LOT... everything has been stripped for a complete buff job, new (white) Faria gauges, new seats and carpet, painting the 225 H.O., undercoating the trailer and more...
motor is off....
MMosher, I was worried about that... without going into it, it looks and sounds pretty solid... I am definitely going to keep an eye on it... Probably won't pull a skier from that side :)
getting the dash back together... new aluminum panel, switches and gauges...
does anyone know where I can get the lower profile and more swept back looking windshields???
You might try this place. It's in the sticky up top - Where to find Cobra Parts
Custom Mold and Tint, Inc.
Monticello, AR
870-367-7083
http://getaboatwindshield.com
Custom Mold & Tint was the OEM http://getaboatwindshield.com/
New Faria Gauges
Nice. Are the wire connections the same. Take out old gauges plug in new ?
champman, these gauges were pretty much a direct replacement, they used the factory wires...
ImpulseRods, what item number or part number are those faria gauges? Also is the third gauge from the left(top row) PSI or water temp?
hotchops777 I don't have the exact part #'s, I got 4 of them from a buddy that never used them in his drag boat. I bought the tach and volt gauge off of Amazon... the third gauge is PSI...
Thanks man, im following your build. Good job so far!
Do you know what the labels/layout of the control panel is? The switches Near the throttle....I just bought 99 201 and the labels are all gone.
nice gauges! i'm changing mine also in the spring....don't know if I'll go with the 100mph speedo though...unless I swap out my XB for a 350 verado.
nice job though...just kidding around..
2000 VIPER COBRA 201D /225 Merc EFI SER: 0T054298
Where does the white go when the snow melts?