Recessed Trolling motor peddle

[Mark Speagle]

Would very much appreciate this information on the recessed tray.

Proud owner of 2001 201DC

Thank you,
Mark

[Irving-NorCal]

Backlash, I really could use that email also. Thank you.

[jhomick]

Hello Gents,

Could you please also forward me the foot pedal install info, I need to do the same for my 201D.
cobra225joe@aol.com
Thanks Joe

[jhomick]

Hello,

Could you send me the pedal install info too please? Thanks Joe.
cobra225joe@aol.com

[jhomick]

Hello,

Can you email the info too please? Thanks Joe
cobra225joe@aol.com

[hookahawg]

Hi folks, I've been trying to get around to installing the tray I bought over a year ago...and finally found a few hours this morning.
I've done it before on a '99 201 it was very straight forward. But just like anything else, measure 8 times then start cutting.
I took a few pics, a couple with measurements. Center line was established using the front seat pole receiver and the front nav light receptacle. Forward edge of cutout is at 4.5" from front lip of deck (see pic)
Took the bow panel off to check for cross braces, wiring etc.....no issues for my install, but like Backlash says, YOUR Cobra may be different.
It took about 2 hours to layout, cut deck and dig out foam. After that,I sealed all cut deck edges with resin, shot bedliner over the newly exposed foam core to add some water resistance should any get in the hole and start to water log....the Permatec gasket applied to the lip of the tray before install should ensure that never happens. Also pre-drilled pedal attachment holes then put a dab of Permatec between pedal and tray at each screw location as well as all screw locations attaching tray to deck. Basically, any gap, hole, space etc. got Permatec before installation.
Hope this helps someone.

tray.jpg

[Backlash Ar]

For those wanting install direction for a recessed trolling motor pedal please eMail me at: lnickelswi@suddenlink.net Thanks!