Looking to add some sturdy trays in the bilge area. They need to sit over the gas tank on the lip under the storage lid. Is this possible? And anyone have recommendations on what to use?
Looking to add some sturdy trays in the bilge area. They need to sit over the gas tank on the lip under the storage lid. Is this possible? And anyone have recommendations on what to use?
" A Few Good Fish"
Please check out my youtube channel
https://www.youtube.com/channel/UCuuwIthNWDweOTGjtkfOVGw
Someone here has done this. I wish I knew how to find the thread. The thread had really good pics. Are you in a 187 ?
GETFISHED !!!
Yup. Sorry about that. 99 187 Elite. I forgot I took my boat out of signature.
" A Few Good Fish"
Please check out my youtube channel
https://www.youtube.com/channel/UCuuwIthNWDweOTGjtkfOVGw
I recently purchased a '99 181 SC and the original owners had put these in the bilge box above the gas tank. I found something very similar, if not the same exact thing on Amazon. He modified them by just trimming them down slightly. Hope this helps.
http://www.amazon.com/Better-Built-S.../dp/B000K2HO0W
20150928_162444.jpg20150928_162459.jpg20150928_162516.jpg
Thanks. dmoto ...exactly what Im looking for.
" A Few Good Fish"
Please check out my youtube channel
https://www.youtube.com/channel/UCuuwIthNWDweOTGjtkfOVGw
That's a neat little setup there. I might have to utilize that on my 181! Thanks for posting.
http://www.bbcboards.net/yamaha-moto...66-photos.html
Scroll down on the thread until you find what you're looking for.
Larry Eby, 2004 ChampioN 188 Elite/2003 200 Hp Vmax OX66
"Romans 10:9"
Thanks Larry
" A Few Good Fish"
Please check out my youtube channel
https://www.youtube.com/channel/UCuuwIthNWDweOTGjtkfOVGw
Brian, I had a friend fabricate this tay for my 202. It fits perfectly and is just what I needed.
P1010166.jpgP1010169.jpgP1010171.jpg
'98 ChampioN 202, 200 Mercury EFI
All great ideas. Thanks for the info. An the pics help a lot.
" A Few Good Fish"
Please check out my youtube channel
https://www.youtube.com/channel/UCuuwIthNWDweOTGjtkfOVGw
Just use a dremel. Way faster and a cleaner cut.
Thank you so much for getting back to me on this. I kinda figured a dremel tool would be the tool of choice. just wanted to check though.