more than likely prob. is touch pad, try a different pad you know is good.
more than likely prob. is touch pad, try a different pad you know is good.
Shot of my rubber "diverter" ... appears to be a piece of the same skid mat rubber up on the bow.
I had to bring this discussion back! I ended up negotiating an excellent price with Ranger for the toggle conversion kit. It was cut in 1/2. Also, today I was reviewing the sponsors at BBC and found the exact Megalink I Needed!!! I don't know where this was 10 months ago
I am happy with my new toggle system, but wish I would've found this! Megalink lives! You should include this in Champion Part links! http://www.bbelectparts.com/
Modified by fishthenation at 8:25 PM 3/4/2012
Did you put the conversion kit in yourself?
Have you called to get a price on the new Megalink?
I just talked to them and the unit is around $400
He has 100 of them!!!
Modified by scotakns at 6:47 AM 3/5/2012
2013 Sea Born NX23
2014 Evinrude ETEC E150DPXABB
'17 200 Elite. I moved from Digital to rocker Switch. I'd love your advice. in 2011, I purchased the components to convert from Megalink to Rocker from Ranger, and had my local service guy do the conversion.
I will FIRST say, I have not had ONE PROBLEM with the new set up in the 9 years! However I have maybe a dumb/simple question.
There aren't "fuses" that I'm aware of. There is a breaker panel. Since I've never had a problem, however I'm troubleshooting a pump issue now, can you tell me, if I were to "blow a fuse" am I correct in saying that within the breaker panel, one of those nubs would pop up? And I would then reset it by pushing down? And of course I need to find the reason for it popping? Or are there fuses that maybe I have no clue about.
Last edited by fishthenation; 04-02-2020 at 02:13 PM.
That is correct for the functions labeled on the breaker panel, however there are 6 fuses in the conversion kit. 3 are behind the switch panel and are for the two timers and tilt/trim power to the bow. The other 3 are in the back of the boat and I covered them in your other post, but 2 are for power to the breaker panel & switch panel and the bilge float switch.
Back to the breaker panel for just a sec. The 2 Accy breakers, one is a 5A and the other a 3A. If you use one or both for electronics, they may be insufficient. I changed both on mine out to 10A breakers since the electronics are individually fused.
Reggie. I didn't know there were 6 fuses. I believe I understand the 3 behind switch panel. I know about the 2 Delphi at the main battery, is the 3rd the 30amp thermal circuit breaker mounted next to my Delphis?