Got my R&R Design pedal tray installed. It doesn't come with a drain, so I used a PVC barb fitting, cut it down and sanded it to make a low-profile drain tube.
1-IMG_0318.jpg1-IMG_0319.jpg1-IMG_0320.jpg
Cut the hole, then sealed all the exposed wood with epoxy resin:
1-IMG_0322.jpg1-IMG_0323.jpg
The finished install (the Ram base I made really neatened up the sonar wire bundle too):
1-IMG_0333.jpg
I might finish the screws anodized-red to match the others on the dash.
Made a new 2-piece GPS antenna mount out of poly - the antenna and transducer cables are sandwiched and rout down through the existing bow light hole. Easy to replace/upgrade!
1-IMG_0339.jpg
Then fab'd a poly rod rack for the passenger rod ramp. Painted the stainless screws and standoffs anodized-red (to match my dash project), and added red bungees to capture rod butts.
1-rodramp.jpg2-rodramp.jpg
Need to bolt it up tight, but should keep reels from clanking now.
Finally, installed some red LED strips for night fishing.
1-IMG_0336.jpg