Recessed Trolling Motor Pedal

[BadBee99]

I want to cut a hole in my deck and recess the trolling motor pedal. Which ones have you all used that works well?

[DaveH]

Check them all out and see what works best for u and do it, believe me u won't regret it, keep the cutout because u can always put it back the way it was if u don't like it.
it will also give u access to the front area of the boat for the boweye and trolling motor mount and electronics.
I belive mine is a trolleze

[mrlawler1]

Pull the front panel off first. Depending on the model of your Bee, there's a support that runs across side to side and you'll cut it in half if you're not careful. In my 03 it was 7 inches from the front panel. Just to be sure pull the front panel..you want regret installing one...well worth it..

[alabamaphoenix]

I installed the troll well II on my 92 pro vee 200. You can see the braces under the deck in the photos.
troll1.jpgtroll2.jpgtroll3.jpgtroll4.jpg

[Thermodude]

Can someone tell me if in the later years did this came standard? Mine is recessed but it appears to have been factory done then carpeted.

[alabamaphoenix]

I bought a new 2008 Bee Line that had the recessed pedal.

[mrlawler1]

If I can find my old phone I may have pics of my install...they may be on here somewhere...have to check and see...

[mrlawler1]

Attachment 118121Attachment 118122Attachment 118123Attachment 118124Attachment 118125[/QUOTE]

Maybe this works, if you'll look at the last picture you can see the cross support on my front deck. On the earlier models that support wasn't there.

[BadBee99]

Attachment 118121Attachment 118122Attachment 118123Attachment 118124Attachment 118125

Maybe this works, if you'll look at the last picture you can see the cross support on my front deck. On the earlier models that support wasn't there.[/QUOTE]




Mine is a 1999 - I will definitely check for crossmember! AlabamaPhoenix looks good too!!! These give me the courage to cut!!!