I purchased this 55' 210 in north Alabama a month ago. After sanding all the paint off I removed all the interior and glass, I then tackled the floor. I've braced the car for the floor support removal, then loaded up with a half dozen 3" cut off wheels and went to work. Progress is good with a couple of weekends and few week nights of work. By the end of Thanksgiving weekend, I expect I'll have the new floor back welded in. Then I'll pull the body from its frame and start on the frame work of sandblasting, adding spring frame pockets and 3" rear lowering springs in the rear with 2" drop front spindles in the front. All four corners will have disc brakes.
Looked like this when I brought it home... While the floor pans needed replaced, the body panels are really solid.
8 hours of sanding.....
Definitely needs a floor...
Cut one side out at a time to eliminate body flex....
Added a new inner and outer rocker...
These are my new pans.....