Anyone know the actual dimensions of the center seat area? I'm going to make a box, but would like to get it built before taking out the seat. Curious if anyone jotted down the actual dimensions for the base.
Anyone know the actual dimensions of the center seat area? I'm going to make a box, but would like to get it built before taking out the seat. Curious if anyone jotted down the actual dimensions for the base.
Been wondering the same thing!
I'm guessing I'm just going to have to pull the seat and measure
When I did mine I believe it was around 19.5 inches wide but can't remember the other measurement. You could probably get a rough estimate by just lifting the seat up without pulling it off.
NITRO Z7
Mercury 150 Opitimax Pro XS
I will try to remember to measure mine tomorrow. I am too lazy to go do it right now.
It's actually a little narrower towards the back. And the bottom corners are curved a bit so take precise measurements at flattest portion of the bottom.
My step that I made is 19.25"x13". It is covered with carpet and it has a little bit of wiggle room. Hope this helps.
How do you remove the back on a center seat 2014 z8?
Mercury 250 proxs 2B115089
got mine stripped out now to install new seats let me know what you need
I built a center box for my 2015 z7.....came out awesome. I made it really deep, it's the same height as the rear deck.
that sound interesting. Any photos?
Joe Allan
Nitro Z7 Mercury Optimax 150hp Lowrance Ghost Simrad NSS Evo 3s
Proudly Supported by: Gamakatsu/Majorcraft/Fuji/Kershaw/Samurai/Atomic
I'll get a picture tomorrow.