So I started on my repair finally with an Evercoat kit that is almost 2 years old. The chip is down to the raw glass and covers red, silver, and black flake. As of now I have covered the red flake and will do the areas of silver and black next. Turned out pretty decent I just need to sand it down where the edges overlap and maybe put a little more clear gel over it where it isn't perfectly even. I am a little nervous to sand it down smooth with the factory gelcoat because the factory gel is very shiny still. Any advice on sanding this down smooth with the rest of the boat? I mixed the flake in with the clear gel, probably would have looked a little better if I followed the directions and blew the flake on then covered it with clear. I think it looks decent thus far.