-
Member
Jack plate digital gauge
Hey guys,
The digital gauge on my atlas hydraulic jack plate isn't working. It still goes up and down no problem but the gauge just shows "- -". I was wondering if there was any quick way to reset the gauge, or how to fix it.
Any help would be appreciated.
Thanks
-
That's a common problem with the Atlas gauges. It is usually the sensor. Loosen the sensor & move it around until it starts to read then retighten. The long sensor bar that goes up & down actually needs to be slightly angled instead of perfectly straight up & down. It's hard to explain but you should be able to see what I am talking about. I can send you photos if you need them.
Good Luck,
Mike
-
Member