Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jul 2004
    Location
    Hoschton
    Posts
    117

    Final Setup numbers 200 HP E-TEC

    With my hot foot and dual trim switch installed (both were very easy to install) I took her out yesterday to see what I could do.

    04 Triton 190 FS
    200 HP E-TEC
    8in Detwiler Hydraulic Jack Plate
    25P Tempest Plus with solid PVS Plugs
    Motor set 2in below pad

    With 2 people, full tank of gas and all our gear: 5700 RPM, 66 MPH GPS, water pressure is over 20 PSI and hole shot is 5 seconds.

    With 1 person, less than 1/2 tank of gas and just my gear: 5800 RPM, 68MPH GPS, water pressure is over 20 PSI and hole shot is 4 seconds.

    My boat came with a Johnson 175 and the best I could get out of her with a 22P Raker turning 5800 RPM was 56MPH GPS, needles to say I am very pleased with a 12 MPH increase.

    FF


  2. Member
    Join Date
    Feb 2005
    Location
    columbia
    Posts
    399
    #2

    Re: Final Setup numbers 200 HP E-TEC (fish finder)

    good info fish..i would be that pleased as well with that increase

  3. Member
    Join Date
    Aug 2004
    Location
    curitiba
    Posts
    231
    #3

    Re: Final Setup numbers 200 HP E-TEC (fish finder)

    Congratulations for new engine
    I think that with so good hole shot you could try a 26
    trophy plus. Maybe you'll get 70
    q290

Similar Threads

  1. F&S Setup and numbers thread
    By TJEli in forum Fish & Ski Boats
    Replies: 46
    Last Post: 03-22-2023, 07:32 AM
  2. Greg 2011 Puma final numbers
    By ibebassin in forum BassCat Boats
    Replies: 4
    Last Post: 03-24-2012, 07:13 PM
  3. Greg 2011 Puma final numbers
    By ibebassin in forum Virginia Fishing
    Replies: 1
    Last Post: 03-24-2012, 04:49 AM
  4. Final Run numbers on Full Load 200 Pro XL and 225 HO E-Tec!!!
    By joeschmoe in forum Evinrude/Johnson Motors
    Replies: 10
    Last Post: 04-11-2005, 05:49 PM