Post Your Phoenix Numbers

[texashawgs]

2018 21 PHX
Mercury Pro 250XS
25p Fury
Bob's Action 12" Hydroplate
1 12' Talon
36v Ultrex 112 60" (will cut down)
4 31 batteries
Best speed so far after just breaking her in: 72 at 5600 rpm
half tank gas, empty livewells, solo
windy with ripples open water
Bob's at 3.5 = 2.5" ptp

coming from a Cobra (had 5), so never had chine before. Finally found that the chine mostly disappears at 2.5" below pad. Still figuring it out. Hoping a 26 fury or tempest will get the speed up but only 5570-5600 rpms with a 25 doesn't seem right to me. Anyone else getting the new 2018 21PHX running faster?

[RIVER RRAT]

2016 920 250 mercury pro xs 25 fury hydraulic jack plate 112 fortress 2 gen 3 hds 9 to fat boys and way to much gear runs a solid 74 im happy

[bassmasher]

2016 819 PRO
MERC 200 PROXS
112 ULTREX
HDS12
HDS10
and a whole bunch of fishing equipment my wife knows nothing about!!
71.4 mph Empty

[Crnkb8n]

2012 721 Pro XP 250 Pro SX 26 pfury two 8’ PPBlades full tournament load two people 73 gps Half tank fuel just me 78gps

[NWFBOY]

2018 919 225 Yamaha sho.
Atlas 10 inch hydraulic
36 volt ultrex
4 batteries
Light load 1/2 tank gas
77 mph

[keysd13]

2016 819 PRO
MERC 200 PROXS
112 ULTREX
HDS12
HDS10
and a whole bunch of fishing equipment my wife knows nothing about!!
71.4 mph Empty

What prop and prop to pad?

[bassmasher]

What prop and prop to pad?

stock prop and never measured prop to pad. Bought it used and all set up already

[rammerjammer]

2014 721 Merc 250 ProXS
10" Atlas Hydraulic, set at 12
24v Fortrex
2 Men (320/200), heavy tournament load
35 Gal fuel
30 degree air 48 degree water temperatures
25p Fury Stock
5980 rpm
75.6 mph

I NEED a 26 pitch Fury or 27 Tempest. I can eat up the rev limiter at this motor height and temperature conditions.

[falconpilot]

2018 20PHX Yamaha 250 SHO
Vmax SHO stock T2-25
12" Atlas Hydraulic set at 14 on guage, 4" on plate - 2" P2P
36v Ultrex
12" and 15" Solix
2-240 pd men
3/4" Full on Gas
Fully fishing load - est 75-100 pds
64 degree outside are, water temp at 53
Water pressure at 22psi
74.2 mph
6110 rpm(this is straight through NMEA from motor to digital display on my Solix so I know it's correct)

Will post video and soon as my crappy internet speeds allow.

Lithium Pro batts inbound so knocking 180 pounds off the rear, ECU flash and Croxton worked 27 T1 on the way as well. I'm betting 80 mph tourney loaded is going to happen, mid-80's with me and light boat..

[Wackyjig]

2018 721 250 Sho
Manual plate at 2.5 ptp
Stock 25 T-2
No Poles 36 V TM 2 guys, gear, and 1 well full for ballast
75.3 and climbing @~6k
Still learning to drive it and had to let out of it.

[falconpilot]

New numbers after the ECU flash. I'd bought a 27 T1 from a guy and had him send it to Mark Croxton direct for a blueprint and tune - unfortunely the guy I bought it from apparently doesn't know what the difference in a vented and ventless Yamaha prop. I received the prop from Mark last night to discvoer its a vented prop which is useless to me..

Anyways, ran the boat today in about the same condition as I did before. Still running the stock 25 T2, with fishing load, 2 guys and 1/2 tank gas, the boat ran 77.4 at 6238 rpm's.....I step out of boat and filmed from shore as my buddy made a pass with only one person - 79.8 mph at 6287 rpm. I was thinking that I'd have to go up in prop size but I believe the 25 T2 is going to work great - when it gets hotter, the rpm will come down some keeping me off rev limiter. I'm still trying to decide if its worth trying a Worked 25 T1 or 26 T1..

My lithuim pros will be in next week which should add another 2 mph which will put me at the 80 mph mark with two people and tourney loaded. With one person and lighter load, 82-83 should be doable...I'll keep you posted with video and picture of proof.

[falconpilot]

Video of 79.8 mph run..

[Rlaurent331]

New numbers after the ECU flash. I'd bought a 27 T1 from a guy and had him send it to Mark Croxton direct for a blueprint and tune - unfortunely the guy I bought it from apparently doesn't know what the difference in a vented and ventless Yamaha prop. I received the prop from Mark last night to discvoer its a vented prop which is useless to me..

Anyways, ran the boat today in about the same condition as I did before. Still running the stock 25 T2, with fishing load, 2 guys and 1/2 tank gas, the boat ran 77.4 at 6238 rpm's.....I step out of boat and filmed from shore as my buddy made a pass with only one person - 79.8 mph at 6287 rpm. I was thinking that I'd have to go up in prop size but I believe the 25 T2 is going to work great - when it gets hotter, the rpm will come down some keeping me off rev limiter. I'm still trying to decide if its worth trying a Worked 25 T1 or 26 T1..

My lithuim pros will be in next week which should add another 2 mph which will put me at the 80 mph mark with two people and tourney loaded. With one person and lighter load, 82-83 should be doable...I'll keep you posted with video and picture of proof.

I applaud how how you basically just say, hell with that warranty!

[falconpilot]

Warranty isn't a problem...limiter wasn't moved..

[john721]

The vents in that prop won’t hurt a thing probably little better hole shot I had mark put them in my sho prop i run small holes runs up too 3500 instead of 3000 rocket out off the hole

[falconpilot]

Boat blows out to 4800 rpm coming out of hole. With my 25 nonvented, it rockets out..

[falconpilot]

Stilling waiting on my Lithium Pros...But I did run the 26T1 today. Bought rpm's back down to 6130 or so, and bought speeds down to 76.2 with two 240lb guys, 1/2 tank gas, and full tourney load. Little surprised by the results as I was expecting the 26T1 to be faster...
https://www.facebook.com/jim.fowler....821686193/?t=3

[falconpilot]

81.4 one person
79.0 with two

[caddyjoe77]

2018 21 PHX
Verado 250
Bobs 6" hydraulic plate.

fastest I have seen so far is 69.1 with about 12 gallons of gas left. Little chop on the water, and ran out of lake. approximately 12 hours on her.

current prop is 25 Fury 3 blade but that is going to change. PVS holes are all plugged. Cant really get a "shallow water takeoff" yet because it blows out.

Thinking of going Bravo XS -- not sure what pitch.

[bassman1403]

2018 20 PHX
Mercury Pro 250XS
25p Fury
Bob's 10" hydro
36v Ultrex 112
4 31 batteries
fishing load
2/3 fuel

I'm really looking for set up help first time with a hydrolic Jack plate long time champion owner and having trouble getting it just right either to much chine walking or just not performing at top speed
any help with setup would be much appreciated