Page 7 of 8 FirstFirst ... 5678 LastLast
Results 121 to 140 of 145
  1. Member
    Join Date
    Oct 2007
    Location
    ORANGE CITY
    Posts
    1,542
    #121
    Alright, question, I was told the 26 Trophy plus has a tendency to sling blades, what replaces it to keep the same hole shot and top end? Thanks in advance .... Robert




  2. Member
    Join Date
    Sep 2013
    Location
    tuscumbia,al
    Posts
    226
    #122
    20xd 2003 250xs rev limiter at 5800 can only turn 5400 rpm my son said 82 mph my first bullet motor 1 half inch below pad how do I get more rpm without speed and handling problems

  3. Member BULLETRM's Avatar
    Join Date
    Feb 2006
    Location
    Burlington NC
    Posts
    977
    #123
    Quote Originally Posted by buoybullet View Post
    20xd 2003 250xs rev limiter at 5800 can only turn 5400 rpm my son said 82 mph my first bullet motor 1 half inch below pad how do I get more rpm without speed and handling problems
    What lowerunit you got? motor is too low either way

  4. Member
    Join Date
    Sep 2013
    Location
    tuscumbia,al
    Posts
    226
    #124
    a sporty with 1.62 gears with a 27 trophy I can only turn 54 or 5500 rpm with a full load

  5. Member
    Join Date
    Aug 2008
    Location
    Spencerville
    Posts
    1,805
    #125
    Raise motor an inch and try it.

    If you see improvement raise it another hlf inch.

    Most 20ft bullets run 3/4 to 1 3/4 above depending on prop.

  6. trapp201pro
    Join Date
    Apr 2012
    Location
    northwest alabama
    Posts
    1,431
    #126
    2013 21SS\2014 300XS L 1.3 DBR 1.75 gears 14"setback-1 1\13 above pad 32 promax-99.3 (interrupted by a 1\4 bolt hitting me above right eye.11-11-16 32 performer 1 13\16 above 66% fuel,me at 295lb and ballast on the other side she ran 100 MPH up-river.there is more there but it takes a gentle hand or it will get upset.The SS is not like other hulls when it blows out,the back-end will wiggle just a little speed drops and the nose falls,it doesnt jerk 1 way or the other it just goes from right to left until you get trimmed down and all the side to side has scrubbed of enough speed.I have had it happen at 75 and 99,its not as bad at 75.theirs more left,just have to be gentle to get it out.
    Last edited by trapp201pro; 11-16-2016 at 08:18 AM.

  7. Member
    Join Date
    Dec 2013
    Location
    Sometimes SC mostly on the road
    Posts
    85
    #127
    96 20xd
    250 pro xb
    10" rapid jack manual (need to change to 14")
    28p chopper unworked
    3/4" bellow the pad
    83 mph gps
    it has alot more ran out of room on falls lake.
    besides i am just learning. need nose cone to go further.

  8. Member opaleski's Avatar
    Join Date
    Mar 2009
    Location
    Florida/Michigan
    Posts
    2,592
    #128
    2013 21XRD
    300 PRO XS
    1.62 Sportmaster
    1.75" Above Pad
    Pro ET 30p
    Light Fishing load and 70 Lbs.of Ballast
    92 mph @ 6200 RPM--
    Last edited by opaleski; 05-14-2015 at 02:54 PM. Reason: New speed and rpm

  9. Member
    Join Date
    Jul 2014
    Location
    Oklahoma
    Posts
    62
    #129
    Bullet250!.2001 Bullet 20 xd.SM 1:62.5700 rpmGps 87.2 water pressure 12/15.11/4 above pad.12" rapid jack.08 250 xs Hydromotive 28 4 Blade blueprinted.Full tank of fuel .3 batteries.Full tackle.Partner and I weight 475 combined.Still working on setup.Bullets are the Best!

  10. Member Bass Bull's Avatar
    Join Date
    Aug 2014
    Location
    Texas
    Posts
    6
    #130
    Wow, NKY Bullet, I have your old boat! I bought it from a fella in Indiana July 2014, It's still in perfect shape and well cared for. I concur your numbers, still running strong. I'm in East Texas around the Beaumont area, and Chris Domino is doing some nice mods on it now as follows..

    Solid mounts, uppers-lowers
    Brucato SVS System
    Fiberglass reeds
    Tuner Mod
    Flywheel Mod
    Swapped to premix
    Titus Nose-cone
    Mercury 28 Lightening ET
    300X Cowl, Pan and Skirt

    Will post pics of upgrades and numbers soon.....
    Attached Images Attached Images
    Last edited by Bass Bull; 11-02-2014 at 06:55 AM. Reason: newby on here, just learning
    Strive for perfection, and settle only with excellence!

  11. Member
    Join Date
    Oct 2007
    Location
    sudbury
    Posts
    2,062
    #131
    Today, Nov 5 2014 .. 2002 21XDC Standard Layup with 2004 250 XS 1:75 Sportmaster , Croxton 31 Hydromotive Q4XOB … 3/4 inch above pad ….. 88.0 mph @ 5850 rpm on GPS , Hbird 1197.. After research I think this is a record for this combo…. Video made and posted on BBC Bullet Forum .. 21 XDC 250 xs Record Attempt...

  12. Member
    Join Date
    Dec 2012
    Location
    Lago Vista Tx
    Posts
    57
    #132
    2011 21RDC with 300xs @ 5900 87.2 gps with power pole, two fishing seats and graphs up and 2 people with full fuel, fishing load and empty live wells.28 p hydromotive qx4. Pictures are before power pole install.
    Attached Images Attached Images

  13. Member opaleski's Avatar
    Join Date
    Mar 2009
    Location
    Florida/Michigan
    Posts
    2,592
    #133
    MODEL PITCH RPM TRIM SPEED HOLESHOT DATE JACK PLATE SLIP D.A. COMMENT
    PROMAX 28 5744 35 85.5 GREAT 5100 9/8/2014 1.5" above
    PRO ET 28 5800 34 87 GREAT 5200 8/22/2014 1.5" above
    BRAVO XS 29 5800 34 85 GOOD 5200 8/28/2014 1.5" above
    PERFORMER BC 28 5625 35 88.1 FAIR-5800 1.5" above 4%
    CHOPPER II 32 5620 32 83 BAD-6000 9/7/2014 1.5" above
    TURBO 0T4 29 29 5500 35 81 FAIR-5100 9/8/2014 1.5" above
    MAZCO 28 RE4 28 6150 35 85 GOOD 6000 9/12/2014 1.5" above
    PROET 28 5988 34 89.1 GREAT 5200 9/14/2014 1.5" above
    TURBO 0T4 27 27 5992 36 88.9 GREAT 4000 9/17/2014 1.5" above
    BRAVO XS 29 6187 35 90 GOOD 5200 9/25/2014 1.75 above 14% Removed front GPS unit
    PRO ET 28 6000 35 88.8 GREAT 5200 9/26/2014 1.75" above 9% Removed front GPS unit
    BRAVO XS 29 6340 35 91 GOOD 5200 11/13/2014 1.75 above 15% Lake Weir no trolling motor
    PRO ET 30 6237 34 92 GREAT 12/18/2014 1.75 ABOVE 16% Lake Weir no trolling motor
    PRO ET 30 6293 34 91 GOOD 5/11/2015 1.75 ABOVE 17% ST.CLAIR RIVER NO TM

  14. Member
    Join Date
    May 2014
    Location
    Auburn, AL
    Posts
    1
    #134
    2002 21XDC
    2002 Mercury ProMax 225x
    Sport Master 1.87
    Prop- 26P ProMax w/ 4 PVS new prop (lost a blade on my 26P trophy plus)
    15" rapid jack jack plate
    .5" above pad

    My best run was 76 gps
    water pressure 20
    RPM's 6100

    The hole shot is horrible on this boat... the prop blows out or loses bite when the nose drops, and when the live well is full it takes forever to get on plane.
    Not sure if I need to lower my motor or raise it. ??????? Thinking about getting a B-Man foil but not sure if it would solve my problem.
    I don't really care about going faster than 80 but I would like to improve my hole shot!

    Any and all suggestions on my set up would be greatly appreciated!
    Last edited by 21XDC02; 06-07-2016 at 01:31 PM.

  15. Member
    Join Date
    Oct 2013
    Location
    Jackson, Ohio
    Posts
    1,991
    #135
    I'm no expert on Bullet set-up but after reading all the set-ups prior to yours, you're running your engine 1 1/2" to 2 " too low.

  16. Member
    Join Date
    May 2015
    Location
    Larose, LA
    Posts
    782
    #136
    96 20xd
    96 200 mercury efi
    Bobs nose cone
    Bobs foil
    10 inch rapid jack 1.25 above the pad
    26 inch hoss triton
    76.1 mph gps loaded to fish with a fat boy and his skinny partner
    If you're going to be dumb, you've got to be tough!

  17. Member
    Join Date
    Jun 2011
    Location
    KENTUCKY
    Posts
    4,002
    #137
    01 20XDC
    02 Mercury ProMax 225x ( Built by Paul Nichols )
    Sport Master 1.87
    Custom built foil
    14" Rapid Jack ( Going to 16" )
    26 ProMax Prop
    1.50 above pad
    Loaded to fish, one person - 81.1 mph and gaining ( learning to drive it )
    2.4 second hole shot
    6350 rpms

    Steven Eversole, KY
    BLAZER 202 PRO V / MARINER 225 SUPER MAG

  18. Member reelman's Avatar
    Join Date
    Jun 2004
    Location
    Palatka, FL 32177
    Posts
    8,182
    #138
    Looks like 98% of spec posts are very old hulls...
    couple of 2013s but huge gap 2010-2015....

    2018 Z19/200 Optimax 2 stroker 24x3 Fury Ultrex 112
    Lowrance HDS 12/9 Lives with 3 in 1 ducers

  19. Member
    Join Date
    Dec 2012
    Location
    Threeway
    Posts
    67
    #139
    1999 20XD, 2013 175 Pro XS, 12 inch set back, 25 Fury at 3 inches below pad. 5800 rpm, 70 to 72 hard loaded to fish in summer time. I run a 26 Fury in winter time, 5900 rpm, same engine height, 72 to 74 hard loaded. Funny how that works but true numbers. Very easy and fun to drive, fishes great. Takes rough water good, Kentucky Lake. Slow Bullet but a great set up for an Ol Man like me. Mostly keep it between 4000 to 4500 rpm, easy on gas that way. Love my Bullet but really love my little 2.5 Merc.

  20. Member
    Join Date
    Mar 2013
    Location
    Georgia
    Posts
    1,475
    #140
    2013 21 SS Bullet with 2013 Yamaha SHO

    topend: so far 87mph with 30 pro max lab finish. Don't want to push it much further, afraid it may blow out.

    prop to pad: 1/2 below

    water pressure: 13psi

    best all around prop: hydromotive 28 pitch o/B Quad4 SSt type B . Top end 86mph

    Topend with two on board and live wells full with fish: 82 to 84 depending on weather.


    0 to 80: 19seconds get some !!!!!
    Last edited by Bradley21SS; 01-09-2017 at 09:13 AM.

Page 7 of 8 FirstFirst ... 5678 LastLast

Similar Threads

  1. Ranger R70 & R72 Performance numbers?
    By strids97 in forum Ranger Boats
    Replies: 0
    Last Post: 02-17-2012, 01:12 PM
  2. 719/619 Performance Numbers
    By Jason Phillips in forum Phoenix Boats
    Replies: 6
    Last Post: 02-24-2011, 12:22 PM
  3. New JP and performance numbers
    By JP_96-181DCXE in forum Champion Boats
    Replies: 16
    Last Post: 05-29-2009, 10:59 AM
  4. Performance numbers
    By sniper222 in forum Skeeter Boats
    Replies: 9
    Last Post: 07-15-2008, 02:42 AM
  5. some new performance numbers for my 06' 20-I / 250 hpdi
    By stratman201 in forum Skeeter Boats
    Replies: 15
    Last Post: 11-26-2007, 12:36 PM