Page 2 of 2 FirstFirst 12
Results 21 to 25 of 25
  1. Member
    Join Date
    May 2015
    Location
    United States
    Posts
    18
    #21
    Will the height of your motor effect how your boat handles and top speed? I have a 99 Bumble Bee 290 Pro Vee and a Mercury 200 efi and it does not have hydraulic steering, the steering wheel about rips out of my hands at WOT. I also can only hit around 63 mph (6000 rpms) with one person and the worst hole shot I have ever seen in a bass boat. I am running a 25 pitch 3 blade. I feel that getting my jack plate just right will make it handle better by getting more of the boat out of the water and increase my hole shot. (BTW others with the same set up are getting 70-75mph http://www.bassboatcentral.com/bumblebee.htm ). Any ideas of lowering or raising jack plate?

  2. Member
    Join Date
    Dec 2011
    Location
    Pool 10
    Posts
    392
    #22
    Measuring your ptp the way the op suggested is not correct. You have to match the angle of the concrete. Most garages are slanted to drain the water off. If the boat and motor are level but you are measuring to an unlevel surface you will not get a correct ptp.
    Pool 10

  3. Member
    Join Date
    Jan 2005
    Location
    hagerstown md
    Posts
    8,406
    #23
    You have to make sure everything is level or on the same plane. If the floor is out level a 2x4 and measure to that.

  4. Member
    Join Date
    Jun 2017
    Location
    Missouri
    Posts
    1
    #24
    What is good measurement for the prop to pad on a cougar FTD with poles, and a 250 SHO?

  5. Member
    Join Date
    Mar 2017
    Location
    Walton, KY
    Posts
    183
    #25
    I don't know if this site allows for linking to other sites. If not, mods please delete.

    I found this article to be pretty helpful.
    http://www.stevescustomprops.com/faq.html

    However, he states 3.5" below pad. However, others have noted and his illustration matches that the pad of the boat whould be at the same level as the center of the water pump inlets.

    I am not sure which is best but, it makes sense to me to be that way.

Page 2 of 2 FirstFirst 12

Similar Threads

  1. how to measure a prop
    By skoty422 in forum Novice Boaters Forum
    Replies: 18
    Last Post: 12-27-2011, 06:49 AM
  2. Replies: 0
    Last Post: 12-30-2010, 06:26 AM
  3. how to measure pad height?
    By wisc glassman in forum Champion Boats
    Replies: 3
    Last Post: 05-19-2008, 03:23 PM
  4. Replies: 7
    Last Post: 04-23-2007, 06:30 PM
  5. 20" shaft where do you measure?????
    By rayz379 in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 08-28-2005, 05:00 PM