VesselView Link Help Needed

[MichaelJ3]

Hey all,

Have a thread going in Merc 4 Stroke Forum, but I’m beginning to think my issue is really more on the Lowrance side than the Merc One.

Here is the link to post 23 where my woes are documented.
https://www.bbcboards.net/showthread...1#post13471247

I do hate to cross post, but I’m at my wits end…lil’ help??

[Team Colibri]

I have VV Link in combination with various units, but I have never looked for water-pressure. I`ll check the next time I`m on the water.

[MichaelJ3]

I have VV Link in combination with various units, but I have never looked for water-pressure. I`ll check the next time I`m on the water.

Thanks Team C.

One note, not all engines support it, most newer stuff requires a Block Water Pressure sender be installed on the engine. Part is around $90 US.

The optimax’s came standard with it, as did the Turbo Verados.
The 4 strokes do not have it standard, has to be added.

[ABQGeo]

Try creating your own set of guages using the builtin app. I've run into the same problem. Couldn't get water pressure to show anywhere on that Mercury app.

Just went out to the garage and fired up the HDS12 and turned the ignition on. Water pressure is showing as you can see.
Screenshot_2024-04-19_15.42.22.jpg

[lpugh]

20240419_213047.jpg

I do no not like the choice's mercury provides so I designed my own shown above,

[MichaelJ3]

That may end up being the route I go..maybe it’s a software error that Merc left it out of their app?