When you set it, do you mash the transducer all the way down leaving only enough epoxy to seat? Or should it not be mashed down hard?
When you set it, do you mash the transducer all the way down leaving only enough epoxy to seat? Or should it not be mashed down hard?
17 Ranger Z520c Black Out Edition
Yamaha 250 SHO
Are you talking about a shoot through or an actual through hull were you drill a hole and fasten/epoxy it in?
"the liberties of the American people were dependent upon the ballot-box, the jury-box, and the cartridge-box; that without these no class of people could live and flourish in this country..."
17 Ranger Z520c Black Out Edition
Yamaha 250 SHO
Mash it down, but not so much that it isn't level.
Surface prep on the face is important. Sand it with 600 grit, and clean it with alcohol first. Might want to warm the epoxy a little bit to make sure it has no bubbles in it.
Mash down, even a little twist.
2014 Phoenix 721XP, 250 SHO, Bobs Action Jack, Dual Blades, 112 Ultrex, 2019 Lariat FX4 F150 Supercrew 4x4
After I mash it down and get level (the best I can tell) I'll place a brick or something heavy on too to keep it from moving or twisting until it's dry ( 24 hrs)....
YOU are not entitled to what I have earned!!!!!
2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS