PP leaks

[mactlman]

has anyone had a ram cylinder leaking at the end cap? mine leaves very small puddles in garage but hoses are bone dry and no leaks seen while running it up and down on garage floor either. just seems to leak at rest? boat has been used 6-8 times at most

[KandKKustomz]

sure its not leaking where line enters cylinder?

[mactlman]

sure its not leaking where line enters cylinder?

was bone dry cycled it up down many times and no dampness at all anywhere- leaks while sitting not under load it seems (bottom of cylinder when in up position) was very wet as was bolts and washers through this end cap

i did snug the line up but was plenty tight and the elbows will be badly mis-aligned if I try to tighten them up also

[KandKKustomz]

was bone dry cycled it up down many times and no dampness at all anywhere- leaks while sitting not under load it seems (bottom of cylinder when in up position) was very wet as was bolts and washers through this end cap

i did snug the line up but was plenty tight and the elbows will be badly mis-aligned if I try to tighten them up also

maybe cylinder seal id advise powerpole... under warranty still?

[mactlman]

maybe cylinder seal id advise powerpole... under warranty still?

picked up in fall of 22 never seen water until july 23 has 8 days use on boat total emailed them but no reply yet

[84rickygreen]

I would call Customer Support. Those guys are AWESOME!

[mactlman]

I would call Customer Support. Those guys are AWESOME!

they are sending me a new ram - sent in serial number and a few emails and it was handled !!