Results 1 to 3 of 3
  1. 03-03-2024, 08:30 PM #1
    Matt_Fisherman
    Matt_Fisherman is offline
    Member
    Join Date
    Apr 2020
    Location
    Kansas
    Posts
    58

    Inner Bearing Grease Seal 1990 Ranger Trailer

    I have the correct grease seal from Ranger. When I go to install the grease seal i tap it in flush to the hub like i have with past trailers and I can litetally pull it out by hand. Anyone ever seen this? Do I need a new hub? Do I need to seat the seal down further into the hub?
    Last edited by Matt_Fisherman; 03-03-2024 at 08:37 PM.
    1990 Ranger 393v Yamaha Pro V 200 HP
    Reply With Quote Reply With Quote
  2. Jake@B4T
    Jake@B4T is offline
    BBC SPONSOR Jake@B4T's Avatar
    Join Date
    Dec 2023
    Location
    Sacramento, CA
    Posts
    14
    #2 03-04-2024, 06:21 PM
    What is the OD of your new seal, on the common stuff they changed from 2.33" to 2.56" if the hub has been replaced it would take the larger od seal. Did the old seal just fall out or did you have to pry it?
    Reply With Quote Reply With Quote
  3. Matt_Fisherman
    Matt_Fisherman is offline
    Member
    Join Date
    Apr 2020
    Location
    Kansas
    Posts
    58
    #3 03-04-2024, 09:25 PM
    Quote Originally Posted by Jake@B4T View Post
    What is the OD of your new seal, on the common stuff they changed from 2.33" to 2.56" if the hub has been replaced it would take the larger od seal. Did the old seal just fall out or did you have to pry it?
    It's weird once it is tapped into the hub it is loose inside and can move freely but can't be taken out of the hub itself without prying. It comes out about 1/4 inch of the hub and gets stopped.
    1990 Ranger 393v Yamaha Pro V 200 HP
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »