Where are you putting the gps/compass puck at the bow? There is not a flat surface on the fiberglass areas at the bow.
Where are you putting the gps/compass puck at the bow? There is not a flat surface on the fiberglass areas at the bow.
I used the cup holder at the bow in my 2015 P2. I cut a piece of plastic, glued it to the rim of the cup, and screwed the sensor to the plastic.
There is a hole already there in the bottom of the cup to feed the sensor’s power wire, and easy access to power at the bow. I’m sure you could do a better job than I did by using thinner plastic and cutting a round disc, but you get the idea. ( disregard the thumbnail pic as I can’t delete it)
IMG_0857.jpeg
2019 BCB Classic
Merc V8 200 4S
20210118_161148.jpg
I never used the cup holder. When I added my ghost I liked Catdudes ideal and done the same. My point 1 is on the Starboard side on the back of the boat.
2013 Pantera 2
200 Pro XS (2b009069)
Ghost Trolling Motor
I never use my cup holder either so that may be the spot
I put mine under the front deck. I flipped the little tripod mount upside down and attached with industrial 2 side tape as far as I could reach in the box. I have a garmin so it doesn't matter direction you just calibrate for however you mount it.
Screenshot_20240303_104311_Gallery.jpg
It's approximately where my finger is
I put mine on the outside of the TM. It is 95% flat underneath.
2014 BassCat Pantera II
Mercury ProXs 200
20240305_165625.jpg
Put it on the cup holder!
2021 BassCatt Pantera II
200 Pro XS(3B056653)
Motorguide Tour Pro
I think that is a throw back cup holder from when everyone drank yellow belly cans while fishing. Other than a can nothing fits in it and cans have this annoying habit of popping in non sandwich side of the ice chest, you know the one with no drain....the one I just finished getting the water out of from yesterday....