Are the transom bolt holes on a ranger aluminum (rb190) sleeved? Or is there raw wood inside there to get wet and rot?
About to add a jackplate. Just wondering what I'm going to find when I pull the motor and knock out the bolts.
Are the transom bolt holes on a ranger aluminum (rb190) sleeved? Or is there raw wood inside there to get wet and rot?
About to add a jackplate. Just wondering what I'm going to find when I pull the motor and knock out the bolts.
When I did my rig a few years back, they had a fiberglass block to distribute the weight.
Note, I add Talon Sandwich brackets between the jackplate and the transom.
I did add some sealant to the hole areas.
(I assume you are using SS bolts. Don't forget to use some type of lube on your bolts when reassembling. To prevent gulling.)
2019 RT 198P
2018 Mercury Pro XS 150 HP 4 Stroke #2B610068
Twin 12' BT Talons
4" Atlas Jack Plate
Riptide Instinct Quest
2018 Ranger RT198p
Charcoal Metallic
Etec 150HP G2 HO
24p Raker Stainless prop
82# MotorGuide Tour Pro TM
Fishes as good as anything out there, with the TM down...