I'm trying to replace my drain plug but this roller is kind of in the way. How do I remove this roller? There's no bolts, both ends are rounded like in the pictures.
I'm trying to replace my drain plug but this roller is kind of in the way. How do I remove this roller? There's no bolts, both ends are rounded like in the pictures.
2004 Stratos 295 Pro XL
2004 Mercury 3.0 L EFI 200 HP SN: 0T908560
Standard/Servicemaster Lower 859399T13
I’m thinking those are just pressed on caps. Before removing its best to have a couple of new ones on hand as you’ll probably destroy the old ones prying them off.
Should be able to remove one of the caps and slide the rod out the other end.
Those caps can be a PIA to remove--- odds are you will ruin it. If you have a Dremel with cut off wheel you can use it to cut the two little tangs off that act as teeth to hold it on.
hardware stores sell the replacement one time use drive on nuts for them buy extra and use a socket to drive one
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Those are a PIA to take off. I use a pair of water pump pliers and wiggle it back and forth while pulling out. They're a one time use so you'll have to get a new one or drill the shaft near the end and use a washer and cotter pin to replace it.
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
I would just leave the boat sitting far enough back on the trailer for the roller not to be in the way. Connect the strap good and snug, make sure the engine is tilted, and ease over to side of the ramp area and replace the plug. Easy....pleasy!
Ranger 2002 175 DVS F115 Yamaha
Ulterra SI, Helix 9 MSI G3 on bow and console
2007 2500 6.7 Diesel Ram 2015 Crusader 294RLT
fish DeGray lake in April & October
Easiest way to remove the cap is drill a hole in it, take a punch and knock the bar out. Most auto parts stores will have new ones.
Ok thanks guys!!! I guess I'll work around it
2004 Stratos 295 Pro XL
2004 Mercury 3.0 L EFI 200 HP SN: 0T908560
Standard/Servicemaster Lower 859399T13
Unscrew and remove the 2 strainers and you will probably have enough room w/out removing the roller.