if there is enough room I will install by fuse block, if not, can I mount it on either the outside/hull side or inside/ center storage box side? What size screws?
if there is enough room I will install by fuse block, if not, can I mount it on either the outside/hull side or inside/ center storage box side? What size screws?
My 2019 919 came from the factory with the HB Enet box next to the fuse block in the starboard rod locker. I will say, I believe I have been having issues in rough water due to where it was mounted at the bottom of that wall. Because that wall is slanted slightly forward, the cables that connect to the front of the enet box were in contact with the floor of the rod locker. No bueno, and when I hit rough water I believe this was causing some intermittent connections (re-syncing and the like). I don't have proof, but I just recently moved it up the wall ~2" so the cables dont touch the floor and so far no issues with my units (two solix 12 gen1's) talking to eachother. My advice, dont mount it all the way at the bottom of that wall. Talking to my dealer recently, it sounds like they are starting to put the enet boxes in the console and that's what I will do moving forward. This also leaves that space open of for the GLS-10 black box. good luck.
Never thought about in the console, I will look into that
Mine was factory mounted in the the console.
2014 Phoenix 721XP, 250 SHO, Bobs Action Jack, Dual Blades, 112 Ultrex, 2019 Lariat FX4 F150 Supercrew 4x4