OK, so my set up is a solix GEN 2and a Solix GEN 1 at my console. On the bow, I have a helix 15. The helix 15 is sole use is for mapping and mega 360. All of these are networked through a five port ethernet switch. When I set the network up, the helix does not show up on the Network. However, the waypoints all show on the map. My question is, why when I mark a waypoint at the console does it not show up on my helix until I reset the complete system. Once it is rebooted and comes back up, it shows the waypoint but not until then. Can someone please help?