How do I stop my Ultrex from “squawking” when the boat rocks back and forth.
i hear it in the aluminum portion if I had to guess.
This is when the Ultrex is deployed.
Thanks
How do I stop my Ultrex from “squawking” when the boat rocks back and forth.
i hear it in the aluminum portion if I had to guess.
This is when the Ultrex is deployed.
Thanks
Not sure exactly what you are describing but for me at least to correct any and all noises, I first had to set my mount up using a level, after leveling the boat. Once I got that corrected I then had to go through the mount and tighten up everything, screws, nuts and bolts. Alot of the hardware was not secured during manufacture. Now the system works perfectly as designed. Hope it helps.
BassCat Puma
250 ProXs
Humminbird Electronic's
Helix 12 G4
Solix 12x2 G3
Mega 360
Mega Live
Minn Kota Ultrex MDI
Relion Batteries
Dexter Suspension System
This is after two summers. Not a new install
But maybe stuff is just loose.
I can guarantee everyone that owns one of these knows the sound.
Put the motor on 10 and do a hard 90. You will hear it then too
rear pivot bushings need to be replaced.
WD 40 or a silicone spray .
I do not recommend WD40. It will attack all plastic parts and make them brittle. A non petroleum based silicon spy is best.
As stated above I would check the pivot bushings. Remove the side plates and you will see them.
See link below.
http://jcracingonline.com/Minn-Kota-...elrin-MKDB.htm
Can I spray around the bushings in the mean time?
Last edited by fishnfireman; 09-20-2022 at 05:54 PM.
I really like my Ultrex, but it squacks/squeaks wayyyyyy worse than any TM I have ever had. Everybody always suggests the bushings….I had mine replaced, and it had very little, if any effect. I also have tightened everything multiple times…no improvement. I would luv to find the culprit.
The motor works perfectly, though.
2019 Ranger z521c (RGR17030E819)
Mercury 250 Pro XS 4 stroke V8 (2B531611)
RangerTrail (7J5BBDK20KF164876)