2004 Pantera Classic here, terminal strip attached to inside transom behind main battery...removed both end screws but will not become free. Is there silicone or similar holding on, or ??? Thanks in advance, Mike
2004 Pantera Classic here, terminal strip attached to inside transom behind main battery...removed both end screws but will not become free. Is there silicone or similar holding on, or ??? Thanks in advance, Mike
Mine was stuck on my 2007 Sabre. I tapped it a couple of times on the end with a rubber mallet and it popped right off. No adhesive on the back.
BassCat Sabre FTD
Mercury 150 Optimax
"It's just fishing"
Ok will give it a try tomorrow, thank you sir.
Hammer didn't work, chipped the one end, afraid I'll break it further. Perhaps BCB will chime in, or I'll purchase a new one and mount near old.
why dont you just call them. It would be faster
BassCat Puma
250 ProXs
Humminbird Electronic's
Helix 12 G4
Solix 12x2 G3
Mega 360
Mega Live
Minn Kota Ultrex MDI
Relion Batteries
Dexter Suspension System
It should just release as they are only screwed in.
Someone may have put silicone or equivalent in the past. Im pretty sure BCB sells this block. On a 04 model if the block hasn't been maintained through the years probably not a bad ideal to just replace it
2013 Pantera 2
200 Pro XS (2b009069)
Ghost Trolling Motor
It should be a stainless steel part and screws.