My motor jerks whenever its trimed all the way up and i try to trim it down, its like if there is air in it ,
it does not come down smoothly until i reach a certain height than its smooth. any ideas what this could be?
thanks!
My motor jerks whenever its trimed all the way up and i try to trim it down, its like if there is air in it ,
it does not come down smoothly until i reach a certain height than its smooth. any ideas what this could be?
thanks!
Nitro z20 2021 with 250 Mercury Pro XS 4 stroke serial # 3B010400
Tighten the tilt tube nuts first. Search this site for the topic. It has been discussed previously.
my 2000 did that its entire life. i torqued the tube nuts and lubed it and it was never better. i just got use to lowering while moving at idle speed and it didn't jump or lowering before starting down to the second ram. have you lubed the tilt pins also?
Last edited by mactlman; 08-18-2022 at 10:03 PM.
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Mine was doing that, also wouldn't trim down from full trim WOT and would kick up in reverse. O-rings on manual release screw fixed it.