I had a meltdown on here a couple weeks ago about the ML update and it being virtually unusable due to interference that was not there prior to the update. Yes, I downloaded in the correct sequence and followed the instructions to a T. At first it was just the interference that was issue. Then the dreaded freezing came back. Past two weekends had back to back derbies so didn’t have the time or patience to mess with it and just unplugged it and ran 360. I’m running all helix’s, 12 mdi g4 & 12 msi g3 (bow) 9msi g3 & 9 mdi g3 console, ml, m360 & Ethernet hub.
Today I finally had time to mess with it. We’ll, I figured something out but I don’t know what to make of it? The 12g3 will run the ML flawlessly if the 12g4 is not powered on? If both are powered on, the g4 will freeze on the ml screen and cause interference or cross talk? on the g3 ml screen. My assumption is there is something corrupt in the g4 update? The good news is I can use my ML again. Bad news is I have a useless helix 12. Suggestions?