Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Oct 2010
    Location
    Powhatan, VA
    Posts
    54

    Calibration on ghost

    I just installed a ghost on my boat and was going through the calibration for the anchor lock and followed the directions but I couldn’t hear any beeps from motor my question is roughly how long do you hold the anchor button down since can’t hear any beeps then release and hold down again before I exit calibration mode

  2. 2022 Ranger Z520R Cup
    Join Date
    Nov 2009
    Location
    Lincolnton NC
    Posts
    206
    #2
    It is a pitch that I can not hear as well, I have to have my wife listen for them. She states she can hear the beep(s) just fine.
    Last edited by ChuckH; 08-05-2022 at 07:19 PM.

  3. Member
    Join Date
    Dec 2004
    Location
    Kissimmee,FL.
    Posts
    230
    #3
    I couldn't hear my beeps either but at pre dawn You can see the light flash on the head.

  4. Member
    Join Date
    Oct 2010
    Location
    Powhatan, VA
    Posts
    54
    #4
    I spoke with lowrance today they said beeps most likely would not be heard due to location of speaker but assured me after you enter calibration mode just press anchor twice and exit calibration mode all would be good I will test this weekend and see if that is true