Results 1 to 3 of 3
  1. 07-29-2022, 07:56 AM #1
    Tim619
    Tim619 is offline
    Member
    Join Date
    May 2016
    Location
    Platte Center, Nebraska
    Posts
    196

    Minimum Expected Water Pressure -BF60A

    I am NEMA-fying my boat. I will have access to the BF60's operating parameters as a result if things go as planned. :)

    My shop manual tells me what oil pressure should be at idle and at what temp range the thermostat should open but it's mum on water pressure.

    Anyone have an idea of what I should expect?

    Thanks!

    PS Honda tech support just referred me back to the dealer. Why would Honda tech support have knowledge of this? Ahem.
    Last edited by Tim619; 07-29-2022 at 08:04 AM.
    Reply With Quote Reply With Quote
  2. Hickory Legend
    Hickory Legend is offline
    Honda / Raymarine Moderator Hickory Legend's Avatar
    Join Date
    Jun 2004
    Location
    Old Hickory
    Posts
    10,928
    #2 07-31-2022, 11:34 PM
    Dont believe the water pressure is a NEMA value. Temp and when the Thermostat opens is the key. As long as your getting a stream and water pressure gauge on the dash should be good.
    Reply With Quote Reply With Quote
  3. B_brand
    B_brand is offline
    Member
    Join Date
    Feb 2018
    Location
    Oklahoma
    Posts
    1
    #3 08-06-2022, 08:19 PM
    I have a BF90A with the NMEA connection to my Lowrance. Water pressure is available and I have it displayed on mine. I can't remember what it is at idle. I think it's around 13 psig at WOT. Next time I'm out I'll check it at idle and post back if I remember.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »