Has any ever had a leak in the actual container that holds the oil mine look to be leaking in the seem of the oil reservoir, checked all fitting etc .
Has any ever had a leak in the actual container that holds the oil mine look to be leaking in the seem of the oil reservoir, checked all fitting etc .
2017 521c 2022 Mercury ProXS 250 4S
Yeah since day one mine leak. Figured it was normal.
Mercury 250 proxs 2B115089
I think it's just the fittings "weeping." The compression fittings on the PIIs were bad, but I still have the same issue on the upgraded hoses on the Blades.
2017 Phoenix 819
2016 200ProXS, s/n 2B359849, Mod 1200P73BD
2017 521c 2022 Mercury ProXS 250 4S
I am actually having the same problem. I finally need to add more fluid after around 7 years. Not a huge deal but it leaks on my onbourd charge..... not ideal.... What can you use other than getting the fluid direct from PP???
Power-Pole Green Marine iso32 1qt 100% bio Fluid on Amazon same stuff PP uses
Risen From The Ashes!!
Check your yellow reservoir caps for cracks. Folks overtightened these, crack them, and they leak.
Is the reservoir overfull? The same cap noted above are vented and contain a synthetic woven insert at the top. Overfull condition saturates the insert and fluid will leak down the side of the reservoir. Turkey baster to remove fluid to correct level and Dawn soap/hot water to clean the insert material (which can be removed from the cap).
DO NOT put that green bean fluid in there!
If you have the green bean fluid in there now it's a PIA to get it all purged out but worth it. The petroleum oil you don't have to fool with for 5+ years.
Plant snot:
It was the reservoir at the seem installed new good to go and my oil was good as new but put new in power pole sent a quart.
Last edited by Bummer; 07-23-2022 at 06:54 PM.
2017 521c 2022 Mercury ProXS 250 4S
Been lucky, mine has never leaked since day one. Gen.1
Replaced all my oil late last year with ISO 32 hydraulic oil. One of them sounded like it was grinding and after some research decided to take the pumps out and clean the screen on the bottom of the pump assembly. They work great now and don't see any leaks.........yet.
Best to get them out and use a Sharpie to mark the lines on the reservoir in such a way you can see them after reinstall.
While any ISO 32 fluid can be used we as well as Power Pole promotes the use of the Green Marine fluid in our Pumps.
I did the same as mike express did. Use a black sharpie on the raised max & min lines, wipe off excess and marks are very legible.
So I guess you do not like doing your part to protect the waters we fish in. The Green fluid is bio friendly. Yeah it costs more, if you are that concerned about the price you can by a different brand that is used in the food industry and meets the spec. Every little bit helps.
Fill the ress slightly below the opening thats where the line is.
Your carrying 50 gallons of fuel, engine oil, & lower unit oil. All contained inside the boat. PP oil is no different. If you use the ISO 32 dino oil it doesn't snot up in 1-2 years and you can go 5 years+ between changes. The dino oil was the original oil specified by PP when they started and is still acceptable.