-
Vessel view module problem
Hello. I have the 2020 mercury 60 hp 4 stroke outboard. Serial number for engine is 1c588346. I installed vessel view module for the android app last year and until last week it worked fine. I had the 2 12 volt trolling motor batteries changed out this past week to 2 lithium batteries. Nothing is hooked to them but the tm. Also took all the accessories and had them put on the starting battery. Added a lithium battery just for livescope and graphs. I checked the 15 amp and 2 20 amp and 25 amp fuses in the engine fuse box and they are good. The module does not light up so it is getting no power now. Am I overlooking something or is module bad? Unplugged it and plugged it back in and no help. Help please. Thanks.
-
-
-
Mercury 3L/4 Stroke/Verado Moderator
Do you have a 5a (or lower) fuse on the engine?
-
No, that was the only fuses on the engine in the fuse box
-
Mercury 3L/4 Stroke/Verado Moderator
Check to make sure:
1. Module is plugged into engine harness with the plug that has the most wires present. Especially important as the other plug does NOT have "power" harness wires (it's used only for "Can Termination").
2. Make sure no pins are pushed out of the plugs on either side of the 10-pin connector (especially the black, purple or red wires).