-
Trim won’t calibrate
Serial # 2B090964
The trim has gauge has not been accurately showing the position of trim on the merc monitor. Will show fully trimmed down when there is more room to go. We installed a new trim sensor, but can’t get it to calibrate. Thoughts on what to look for? Motor trim is working, from the blinker trim, throttle trim, and front of boat trim switch.
-
Member
What was the part number of the trim sender you recently installed?
USN Retired
2020 Basscat Caracal
2020 Mercury 225 ProXS 4s
-
Will have to get the number, my son ordered, likely using the parts diagram from Europeans website
-
-
Mercury 3L/4 Stroke/Verado Moderator
Should work fine.
Make sure that the wire colors MATCH (black goes to Black w/Orange Stripe). NOTHING connects to the Brown w/white stripe wire.
Remember that you have to run trim down fully and stall it against DOWN for 3-4 seconds. Save that as full-down.
Raise to end of short rams (JUST before the faster operation starts). SAVE that as Maximum TRIM position.
Raise to the highest possible TILT angle you can achieve without contacting the cowling or damaging steering. SAVE that as maximum TRAILER position.
Save and exit your way back to main menus. Should work properly- if it does not, check the TriLobe Pin.
-
Just a quick thanks, we were not calibrating correctly
-
Mercury 3L/4 Stroke/Verado Moderator