-
Unit Updates - For Helix 10 G4Ns and Mega 360
Good evening everyone,
This spring I purchased a new to me Bass Boat that has Four Helix 10’s, Three G4N MDIs and One G4N MSI. The boat also has Mega 360 connected to one of the Helix’s on the Bow.
All of the graphs are linked.
I have been experiencing some some weird issues with the Units, and I’m hoping software updates will help remedy some of the problems.
One big problem I’m having, is when I’m trying to use the MSI at the dash, I will get a pop up that says “Mega 360 Not Detected”, and my graph will cycle to the next page. I can flip back through the pages to the MSI, but the pop-up will appear again after a minute or two and the page will cycle again.
Another prevalent issue, one of lesser importance, is an error that will pop up saying “Temp Source 1 not detected”, and none of my graphs will give a temp reading. Another issue is randomly, MSI will just go dark, not showing anything. This issue seems more sporadic, as sometimes it will run with no problem.
My main question, since my graphs are all linked, when I go to update the Mega 360, should I do that update on all of the graphs or just the graph that the Mega360 is wired to?