Results 1 to 3 of 3
  1. 05-15-2022, 11:55 AM #1
    luigirox
    luigirox is offline
    Member
    Join Date
    May 2022
    Location
    Chi Town
    Posts
    2

    EDGE Bow Mount Transducer Wiring Help

    I need help with the correct way to run the transducer wiring on an Minn Kota Edge Trolling motor.
    I can't seem to find a lot information on this.
    Thank you in advance.
    Reply With Quote Reply With Quote
  2. luigirox
    luigirox is offline
    Member
    Join Date
    May 2022
    Location
    Chi Town
    Posts
    2
    #2 05-17-2022, 06:42 AM
    I will installing this tomorrow.Any help would be great. Is there a video or a diagram of running the cable?
    Reply With Quote Reply With Quote
  3. Bill Reynolds
    Bill Reynolds is offline
    Member Bill Reynolds's Avatar
    Join Date
    Aug 2013
    Location
    The Diamond State
    Posts
    3,865
    #3 05-17-2022, 03:09 PM
    I don’t have an edge but when I had a MAXXUM, I taped the transducer cable to the shaft with a loop at the split large enough that the shaft can rotate 360 degrees.
    Once I reached the head, I taped it to the cable sleeve nearly to the foot pedal and then on to the graph.

    This is the only pic I have and it is not very close up.


    I try to drive as if my 16 year old Grandson is following me
    Speak as if he is listening and act as if he is watching
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »